| Products List |
|---|
 Automobile Plastic Mould |
|---|
| >>Automobile Plastic Parts |
|---|
| >> Plastic Motorcycle Parts |
|---|
| Home Appliance Mould |
|---|
| >> TV Plastic part mould |
|---|
| Household Commodity Mould |
|---|
| >> Baby Plastic Parts |
|---|
| >> Plastic Chair |
|---|
| >> Plastic Container |
|---|
| >> Plastic Crate |
|---|
| >> Plastic Dustbin |
|---|
| >> Plastic Flower Pot |
|---|
| >> Plastic Pallet |
|---|
| Extrusion moulds |
|---|
| >> Feedblock |
|---|
| >> Gear pump |
|---|
| >> Screen changer |
|---|
| >> Static mixer |
|---|
| >> T-dies |
|---|
| Contact us |
|---|
| TEL:0086-576-84355158 0086-576-84352158 FAX: 0086-576-84357158 MOBILE: 0086-15057227888 E-MAIL: info@jnmould.com WEBSITE: www.jnmould.com |
|---|
 PRODUCTION EQUIPMENT |
|
|---|
| 1. mould design | 2.mould-design achievement | 3.workshop profile |
|---|
JINNUO MOULD are good at using mould flow to find the problems at the beginning and pay attention to them in design and production process,work out the solutions.Therefore reduce risk,lower costs,shorten the construction period and improve quality. |
|
|---|---|
| Moldflow Examples : |
| 1. Filling time_TV cover | 2. Shrinkage_pail |
|---|
 |
 |
|---|
| 3. Flow mark_40’Front cover |
|---|
 |
 |
|---|---|
| Hot runner with 6 valve gates, from the fill process, we can see hesitation on the top center. And there are weld lines on the main surface. |
No.1 opened first, when the melt front reached the No.2&3gates, No.2&3opened, then the No.4&5 opened, in this mode ,the top side may filled before the under side |
 |
 |
|---|---|
| Although the runner is unbalanced, but we can control the time of the valve gates to decrease the influence of the unbalancedflow. And the 4 gates on the top side can give a good compensation for shrinkage. |
Most of the weld lines happened on the grid, there are no weldlines on the main appearance. |
 |
|
|---|---|
| Air trap happened near the grid |